Update 1:

most likely due to the 1.0 update it worked fine i to noticed that the drones went to wrong locations to

Just a quick FYI; The 7 open drone ports all have the same name, which (at time of writing) bugs out the destinations of named Ports. In my case, I made some basic stuff (plates, rods, concrete) and set them to transport to the main building. After doing that and checking if i did it right, they switched to Encased beams drone port and some other randoms. Fixed it by naming the empty drone ports 1 through 7, and now it works fine. Might want to update your Mega blueprint and just add in those numbers to avoid future troubles! Excellent build regardless

thanks for bringing this to my attention, i altered the blueprint. i hope it workes better now

i will work on it

lagfest related to my crappy GPU i guess. a 4080 might be good here ;) for the rails: on the northern part of the building are rails from GRN colliding with those round concrete pillars of yours. the rails (and pillars) from latest GRN will clip through your building on that northern side. test is done in 5mins; just load both blueprints and see where they overlap ;)

it runs perfectly on my pc, also no problems on the rails here i tested it out for hours before i posted it

a beauty by day, a beast by night! :) with lights on, this beautiful build turns into a massive lag-fest with single-digit FPS (had to look down to the ground to be able to walk towards the lights controller ;D) some minor rail adjustments have to be done to fit onto latest GRN as well so it won't clip through each other and connect properly. had to delete some GRN parts and re-connect them to one of the inner upward-spirals. no biggies though. a proper 4 out of 5 i'd say for sure! thnx 4 sharing! :)