This still works. However it’s broke for 1.0. You need to replace the sulfer node. The caterium node and also the quartz node before starting it! They have all moved! After that it will work fine! It doesn’t take but a few minutes

this makes 0 sense, to make the 6 uranium control rods for the reactors you need an input of 600 uranium per minute, even in update 4 where this was made. it needs 600 uranium per minute yet you only allow 300 per minute, this makes no sense at all

Still a great blueprint. Works in 1.0 with a few small changes, but they're quick to make. Quartz, Caterium and Sulfur nodes need to be repositioned. The recipe in the mixer where the uranium is processed needs to be adjusted with summer loops, as the uranium node only spits out 300p/min.

Works great, seems to stay balanced for the 3+ hours I've played with it so far. Logistics are handled well and lighting is used to great effect. A few suggestions for improvements: aesthetics are a bit lacking (plain foundations are so ugly!), better wire management, addition of a hypercannon to the existing hypertube, close enough wiring to support the hover pack, way to easily traverse to higher floors of the large factory, addition of signage to communicate how everything works, and removing clipping with the Global Rail Network blueprint.

@BlazerBuddy There is a switch called "Start", Disconnect and re-connect the wire on its both left and right connection node. Then you can see that there is a light switch beside that "Start" switch, and there is a power pole on the right side of it, and it's connected to a node on the edge of the power storage zone. Diconnect and re-connect that wire, then you are good to go. Guess it's got to get those power storages running to drive all those power plants to make it all good. And by the way, in the desciption it says "all concrete". It's not concrete, right? And concrete foundations cannot block radiation...

@shilei97.1 How would I turn it on then? May u explain which power pole I have to go to to turn it on?

@BlazerBuddy I have tested it and yes it works, because it uses all vanilla things. However there is no "beacon" as supposed to be as said in description, so I had bee doing diagnostics on the power connection for hours until I figured it out how to get it running.......

Does this still work in Update 5? I want to know before I download it.😀

Where is the beacon? I installed the blueprint and see no beacon in game.