I fully agree with @zinjin below ... and fully disagree with @Omniwrath below either (who does not read the description and wants a design already done, ex. Hornslet who does it beautifully) !! This design is made for you to have a starting network, a foundation, directions and possible paths, and a basis for improving and creating then you personalised system. It is perfect for discovering the map and area step by step. I would advise though to delete some tracks, so you can isolate the part on which you work, see and test, and for isolating the work-in-progress so then the power is only for the section on which you work. Thank you !!

Appreciate the print, but there are no signals was there the space to throw down a station anywhere near my base.

Amazing! nicely placed tracks and i don't mind putting signals as doing so while exploring the map anyway. imported it to an already quite late new save in rocky desert and could easily integrate into my existing network/delete some unnescessary tracks

I just wanted to take the time to thank you for this perfect print. The mind-numbing track laying is no longer something I have to do, but there's a LOT of opportunity for my creative side to take over later. This gets the rails down and I can immediately start dropping stations anywhere on the map.

It does feel cheaty, but it's the only print I will use because of just how much work is still left to be done. I set up block signals and clear vegetation on each line as I build them, so it's still a dopamine lover's dream.

Thanks!

Any update on the updated version?

Hello, thank you already for this very practical blueprint, just a comment to notify a rail not connected to the following coordinates on the interactive map : 122.091 / 239.592

Thank you for this build. Laying down the tracks is the most dreaded part for me. It's honestly quite fun following the tracks, exploring and placing signal along the way. A good distraction from factory building. Gonna be fun to figure out how to decorate the whole system.

Hi, what is the curent progress level of the trafiic signal works?

@craftybob the Plan is zu drive like in Germany. But u can decide by your own because you have to set up the Signals. Feel free :)

schokyomomg i will as soon as possible :)

@Omniwrath I'm sorry to hear that. But as I said in the description, this first version is very rudimentary and I deliberately decided against signals because a) I wanted to satisfy my inner monk so as not to cheat too much and b) because I want to give you the freedom to design the rail network the way you want. Signals work a bit differently with 1.0 than before and of course this means that you have some work to do with it. I have that too. Version two will be with signals and some stations, version three will be completely final.

Please make this nice Railway again, but with block signals. Thanks.

Do not bother with this blueprint at the moment. Unless you want to walk every inch of the rail and place intermittent block signals, it's useless. If you place block signals at your stations, the entire railway in the blueprint will only allow 1 train to use it simultaneously. And if you don't use block signals, your trains will collide. I regret adding this to my world and it never should have been released like this.

Is the intention to have the two lines different directions? If so, are we driving in Germany or in Ireland? Thanks!

Rails are absolutely beautiful, work looks amazing so far although I haven't looked through all of it. Does not have path or block signals, hoping for an update/another mega print with signals. Awesome work

This has no block signals. Does that mean block signals should not be used anywhere on the network? Or do I need to traverse the entire network placing block signals to make it functional?

Well done, i like it if its close to the ground often.