This blueprint is intended to be used along with my other blueprint Drone Platform - Nitrogen Receiver/Unpackager (link). The Unpackager platform (the other blueprint) unpackages the packaged gas and then returns the Empty Fluid Tanks back to this platform.

The idea behind this blueprint is to extract and package the nitrogen gas, and transport it out via drones. The drone stations on top operate in pairs. One transports the packaged nitrogen gas to the receiving station, and the other returns empty tanks back from the receiving station.

The setup can handle a throughput of 600 per minute, even if your Extractor platform and Receiver/Unpackager platform are at opposite ends of the map.

Each drone station pair handles two Normal nitrogen gas extractor points. These are numbered so you can match them up.

To use this blueprint, just place a single 2m foundation on the ground where the Resource Well Pressurizer will be placed (try to center it over the Pressurizer placement location as closely as you can, but if it's off a bit it will still be fine). Then paste this blueprint onto that foundation. After it's been placed, you can place the Resource Well Pressurizer and the Extractors. Then just connect up the pipes and power, and configure the drone transports.