Ultracompact Intermediate Coal 1350MW Mk.3

A tiny, standalone coal factory for Mk.2 miners and Mk.3 belts.

In:

  • Coal 270/min

Out:

  • 1350 MW

Info:

  • Size: 4x5 (Vanilla Mk.2 Blueprint Designer)

Instructions: Connect power, wait until water extractors stop running, and connect coal.

Please leave a rating if it works, and a comment if it doesn't!

If you find any bugs or have questions, find me on Discord as .mustard. (must use both periods)
  • Created on 30‏/01‏/2025 9:04:33 م
  • Last updated on 30‏/01‏/2025 9:05:41 م
  • oj1811 - 23‏/06‏/2025 9:11:47 ص

    Please make a 5000mw fuel power plant

  • mustard - 07‏/02‏/2025 3:54:29 م

    Yes, the only Mk.3 belt/lift this needs is the input line, which you build into the splitter! It immediately splits into 3 different belts (270/3=90) so only Mk.2 belts are needed until the next splitters which are another 3 way split (90/3=30) where only Mk.1s are needed. There's a final 2-way split into the gens themselves (30/2=15) so Mk.1s are used there. You could upgrade everything, but since this is fully load-balanced and gens only use 15/min, nothing would run faster than it does already and you'd just waste some steel. If you designed this as a manifold, then yes, you would need Mk.3 belts and you'd also have to wait a lot longer for the buffers to fill and for the last gen to turn on. So long story short: this comes online faster than a manifold design and uses cheaper/easier components to build.

  • Cha0ticDreamz23 - 07‏/02‏/2025 3:13:39 م

    why are you using mk1 belts & mk1 Lifts please??? I am feeding in coal with mk3 belt